Publicité
Les langues disponibles
Les langues disponibles
8. NOTE: Do not overtighten the bolts or you may crack the plastic base.
9. Proceed with the assembly process as outlined in section ASSEMBLING THE SOLAR SHOWER.
ASSEMBLING THE SOLAR SHOWER
1.
Once you have completed mounting the bottom half of the shower in your desired location you are ready to finish the
assembly process.
2.
Attach the elbow tube to the shower. Attach the large shower head to the elbow tube. Use Teflon tape at both
connections to eliminate leaks - see Figure 1.
For the assembly of the upper and lower parts of the solar shower, see Figure 2 . NOTE: The fit between the upper and
3.
lower tubes is very tight. It may be necessary to pull down on the upper tube while wiggling from side-to-side to make
the connection is complete.
4.
Once the upper tube is completely seated into the lower tube, secure the joint by tightening the locking ring.
5.
Attach a garden hose to the inlet port of the shower on the back side of the shower. Insert the included hose washer into the
inlet port. Make certain that stainless steel tube assembly is securely tightened.
6.
Be sure the garden hose is placed safely to avoid any tripping hazards.
NOTE: The maximum operating pressure for the solar shower is 43.5 PSI (3 bar). Operation of the shower with higher
pressure may cause NON-WARRANTY damage.
- Example of
assembly
2
Publicité
