Carton Contents; Connection - FRENETIK Resist 5 Manuel D'utilisation

1. Carton Contents

- 1 Resist 5 speaker
- 1 bracket
- 1 cable gland
- 1 user manual

2. Connection

For connection to a Dante™ network, connect the RJ45 socket, with a Cat 5 or Cat 6
network cable, to an Ethernet Switch, accepting a minimum 100 Mbit/s Fast Ethernet
link speed. The connection is also used to power the speaker via the network using PoE
(Power over Ethernet) technology. A PoE switch or PoE injector must therefore be used.
To achieve full power, a PoE+ power supply according to the IEEE 802.3at-2009 «PoE+»
standard must be used.
3. Configuring a Dante™ Network
1) Start the Dante™ Controller software.
2) Wait until devices visible on the network appear in the software matrix. Note: If a device
does not appear, there are several possible reasons including :
- the device is not switched on/powered
- the device is in another subnetwork
- the device cannot be synchronized with other Dante™ devices
For either of the two reasons listed last, the Dante™ device must be visible at least in the
Network View under the «Device Info» or «Clock Status» tab. Stopping and then restarting
the speaker could be a quick fix to the problem. Further information can be found in the
Audinate Dante Controller manual.
3) From the Dante Controller menu bar, select «Device / Device View» or press the Ctrl+D
key combination. The «Device View» window will appear.
4) From the drop-down menu below the menu bar, select the speaker to be configured.
5) In the third tab «status», various information about the device is available.
6) Click the «Device Config» tab. If necessary, adapt the «Sample Rate» to that used in the
network Dante™ (all devices must have the same sample rate in order to work together).
7) In the «Rename Device» field, you can change the name used for the device in the Dante
network for better identification. Confirm any changes by pressing the «Apply» button.
8) From the «Network Config» tab, you can, if necessary, change the network settings for
the Dante™ interface of the speaker.
User's manual - Resist 5 V2.1 03/2022 8/12