Télécharger Imprimer la page

Spector&Co SPECTECH T223 Mode D'emploi page 4

Publicité

Les langues disponibles

Les langues disponibles

2. Answer/End incoming calls: press
3. Reject incoming calls: press & hold
4. Volume control & skipping songs must be controlled directly on your audio device
NOTES:
-
The Primary speaker flashes Blue & Red LED, while the Secondary speaker flashes Blue
LED only
-
Incoming phone calls will disrupt music play. To resume music mode, press the multi-function
button of one of the speaker units or the play button directly from your audio device.
Connecting T226 speaker by AUX mode (Stereo Mode – 2 speakers)
1. Power ON both speaker units.
2. Allow 5 seconds for the 2 speakers to automatically pair to each other
speaker flashes Blue & Red LED, while the Secondary speaker flashes Blue LED only)
3. Plug in 3.5mm AUX audio cable into the Primary speaker & into your audio device
4. Volume control, skip/previous songs & incoming calls must be controlled directly on your
audio device
Connecting T226 speaker by AUX mode (Mono Mode – 1 speaker)
1. Power ON either speaker.
2. Plug in 3.5mm AUX audio cable into the Primary speaker & into your audio device
3. Volume control, skip/previous songs & incoming calls must be controlled directly on your
audio device
To Re-charge the T226
1. Insert micro-USB cable into the T226 speaker units & connect the USB output to a certified
a/c wall adapter (not included)
2. A solid Green LED indicates that the T226 is charging (LED will automatically power OFF
once the T226 is 100% fully charged)
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
button once on Primary speaker
button on Primary speaker
(NOTE: the Primary

Publicité

loading

Ce manuel est également adapté pour:

Spectech t226