Publicité
Les langues disponibles
Les langues disponibles
3. Reject incoming calls: press & hold
4. Volume control & skipping songs must be controlled directly on your audio device
Connecting T223 speaker by AUX mode
1. Plug in 3.5mm AUX audio cable into the T223 & into your audio device
2. Volume control, skip/previous songs & incoming calls must be controlled directly on your
audio device
To Re-charge the T223
1. Insert micro-USB cable into the T223 & connect the USB output to a certified a/c wall adapter
(not included)
2. A solid Green LED indicates that the T223 is charging (LED will automatically power OFF
once the T223 is 100% fully charged)
T226 Instructions (2 speakers)
T226 Operation
1. ON: Press & hold the Power Button ON on each speaker
2. OFF: Press & hold the Power Button OFF on either one speaker to power off both speakers
NOTES:
-
previously paired devices will automatically re-connect to the T226 when both devices are
turned on & within range
-
The T226 will automatically power OFF when inactive for approx. 10mins
Pairing an audio device to the T226 (Stereo Function – an audio device wirelessly connected to
2 speakers)
1. Power on ONE speaker unit of T226
2. Quickly press
3. Power on secondary speaker. The 2 speakers will automatically pair to each other within 30
seconds.
4. Make sure the Bluetooth setting on your audio device is ON
5. Search for the Bluetooth signal Spector T223/T226 on your audio device & pair (an audio
prompt will indicate successful pairing)
6. Speakers can be used magnetized together or separately on a flat surface.
NOTES:
If the Spector T223/T226 Bluetooth signal does not appear on your audio device, power off
one speaker unit, refresh the Bluetooth signal from your audio device & repeat steps # 1-5
The Primary speaker flashes Blue & Red LED, while the Secondary speaker flashes Blue
LED only
Previously paired devices will automatically re-connect to the T226 speaker when both
devices are turned on & within 10 meter range
The built-in magnets of the speaker units have a strong magnetic pull & can be placed on
metal surfaces & structures (ex: magnetic whiteboards)
Pairing an audio device per speaker (Mono Function for each Speaker)
The T226 allows users to pair 1 audio device to 2 speakers (stereo mode) or pair 1 audio device to 1
speaker (mono mode). Please see instructions below to pair 1 audio device to 1 speaker.
1. Turn ON ONE of the T226 speaker units
2. Make sure the Bluetooth setting on your audio device is ON
3. Search for Bluetooth signal Spector T223/T226 on your audio device & pair
NOTES:
nd
-
To pair the 2
speaker to a 2
meters away from the 1
T226 Wireless Speaker Function
1. Play/Pause: press
button twice. This will set the speaker unit as the Primary speaker.
speaker with a different audio device, repeat steps #1-3. When pairing the 2
nd
st
audio device, the 1
st
speaker.
button once on either speakers
button for 2 seconds
speaker must be powered OFF or pairing must occur 10
nd
Publicité
