T&S B-7161-C Instructions Pour L'installation Et La Maintenance page 6

General Instructions
Service
CAUTION: Remove all tension before servicing. Hazards or unsafe practices may CAUTION: Remove all tension before servicing. Hazards or unsafe practices may
result result in minor personal injury, product or property damage. in minor personal injury, product or property damage.
WARNING: Before performing any service, always disconnect and lock out WARNING: Before performing any service, always disconnect and lock out
compressed compressed air or fl uid, and remove all spring tension. Hazards or unsafe air or fl uid, and remove all spring tension. Hazards or unsafe
practices could result in severe personal injury or death. practices could result in severe personal injury or death.
HOSE REPLACEMENT
• Remove shroud screws and shroud (Fig.4).
• Remove all tension from reel. See "TENSION
ADJUSTMENT. " Pull hose
until ratchet "clicks" several times.
• Remove spray valve using 1/2" wrench.
• Pull hose back through guide and unwind
hose completely.
• Rotate reel through "clicks" until hose
connection is exposed.
• Use 9/16" wrench to remove hose
connection from reel.
• Place new hose connection onto reel (no
sealant needed).
• Feed hose around hub, following direction
of arrow on hub shown (Fig.5).
• Wind until hose will fi t through hose guide
about 1 foot long.
• Reattach spray valve. Check for leaks.
• Check tension. Adjust tension as needed in
"TENSION ADJUSTMENT " section.
• Reattach shroud and screws.
• Mount on oven and reattach plumbing.
RATCHET LOCK REPLACEMENT / REMOVAL
• Remove all tension, see "TENSION ADJUSTMENT. "
• Remove shroud and screw (Fig.4). Loosen top
screw (Fig.6) Use e-clip remover and disengage
e-clip from swivel (Fig.6).
WARNING: Failure to use proper e-clip remover tool WARNING: Failure to use proper e-clip remover tool could result in injury.
shroud
loosen top
screw
directional arrow
e-clip groove
could result in injury.
6
Figure 4
screws
Figure 5
Figure 6
top screw