Setting Up; Initial Settings; Starting And Exiting The Application - Sony PWS-100MG1 Mode D'emploi

Setting Up

Initial Settings

Before using the unit, configure the Windows settings
within the unit. The description below describes the
standard settings in Windows 8.
Note
To reboot the unit, first shut down the unit and then turn the On/Standby
button on the front panel on again, without rebooting Windows.
1
Connect a keyboard and mouse to the USB connectors
on the front panel, and connect a monitor to the
DisplayPort connector or HDMI connector on the rear
panel.
2
Turn the On/Standby button on.
3
When the Windows login screen appears, enter "mgw"
as the user name and "mgw" as the password, and log
in.
Configuring the network
1
Connect a LAN cable to the LAN connector on the rear
panel of the unit, and connect the other end to the
network.
2
Click [View network status and tasks] under [Network
and Internet] in the control panel.
3
Click the device connected by LAN cable in
[Connections].
4
Click the [Properties] button.
5
Select [Internet Protocol Version 4 (TCP/IPv4)], then
click the [Properties] button.
6
Change the IP address and other settings.
7
Click the [Advanced] button to configure DNS,
WINS, and other settings.
8
When finished, click the [OK] button.
Setting the date and time
1
Select [Set the time and date] under [Date and Time]
in the [Clock, Language, and Region] control panel.
2
Click [Change time zone] on the [Date and Time] tab,
and select the time zone.
3
Click [Change date and time] on the [Date and Time]
tab, and set the date and time.
4
Click the [Change settings] button on the [Internet
Time] tab.
5
Specify an NTP server, then click the [Update Now]
button.
6
Place a check mark in [Synchronize with an Internet
time server] to periodically correct the clock using the
NTP server.
Signing out
When finished, sign out from Windows.
1
Move the mouse cursor to the top right corner of the
screen to display the Charms bar, then click [Start].
2
Click the account name on the top right of the screen,
then click [Sign out].

Starting and Exiting the Application

Starting PWA-MGW1
1
Turn on the unit.
2
Launch Google Chrome.
3
Enter the "localhost:8080" URL in the address bar and
press the Enter key.
If the login screen does not appear
In the Chrome menu, click [Settings] > [Show
advanced settings...] > [Reset browser settings] to
reset the browser.
4
Enter your user ID and password to log in.
Notes
•
PWA-MGW1 does not support the sleep function. You should ensure
that the unit does not go to sleep during operation.
•
To change the Help interface language (English/Japanese/Chinese),
change the Language setting in Google Chrome.
In the Chrome menu, click [Settings] > [Show advanced settings...]
> [Languages] > [Language and input settings...] and drag the
desired language to the top of the list.
15
Setting Up