Greenway Home Products Muskoka MEF2873CW-1 Instructions D'assemblage page 4

Step 5
Locate the upper facing panel that will be attached to the left and
right side panels and will sit above the central header. Position this
panel with the finished side facing the front of the mantel. Line up
the holes on each side and insert and tighten 2 wingnuts and 2 lock
washers on each side.
Step 6
Get your assistant and locate the top of your mantel. This top is very
heavy. It will take 2 people to lift and position it in place. Ensure the
top goes over the positioning guide located on the header. The top
must go over this guide to be positioned correctly. Line up the holes
on the top of the mantel, insert and tighten 4 wing nuts and 4 lock
washers.
Step 7
If you are using this mantel in a corner application, locate the triangular
piece of wood which attaches to the mantel to create the corner unit.
You must attach this piece for all corner applications. Slide the corner
bottom support into the channel located at the middle of the back of
the hearth base. Place the top corner attachment on the floor upside
down. Protect it from damage. Attach the corner upright support to
the corner attachment by lining up the hole in the corner upright
with hole in the corner top then insert 1 wingnut and 1 lock washer
through the holes in the block and tighten. Simply take the triangle
and slide the brackets with the holes onto the pins which are already
attached to the mantel. Once the triangle is attached, push it up so
it is level with the mantel and lock it into place. To lock it into place
simply turn the horizontal wooden blocks attached to the underside of
the mantel into a vertical position to support the weight of the corner
triangle. Now attach the corner bottom support to the corner upright
support by insert and tightening 1 wing and 1 lock washer through
the holes at the end of each piece.
3
Step 5
Step 6
Step 7