Greenway Home Products Muskoka MEF2873CW-1 Instructions D'assemblage page 3

GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging.
DO NOT use a box cutter or exacto-knife as you may cut into the
mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging, taped
to the top box. Be sure you DO NOT discard any pieces.
Step 1
Locate the base and place it on the floor. Do not put it up against the
wall at this point in the assembly, as you need to get in behind the
mantel to insert several wingnuts, lock washers and firebox screws.
Step 2
Locate the left side panel and the left front panel. Facing the front
of the base, take the left side panel, positioning it so the holes in
the blocks on the bottom line up with the holes on the base. Position
the left front panel next to the left side panel, lining up the holes in
the blocks with the holes on the base. Attach the left front and side
panel to the base by inserting and tightening 1 wingnut and 1 lock
washer to each block. Attach the left side and front panels together
by inserting and tightening 3 wingnuts and 3 lock washers through
the holes in the 3 blocks.
Step 3
Repeat Step 2, but with the right side panel and the right front
panel.
Step 4
Locate the central header that will be attached to the left and right
front panels. Position this panel with the finished side facing the front
of the mantel. Line up the holes on each side and insert and tighten 2
wingnuts and 2 lock washers on each side.
2
Step 1
Step 2 & 3
Step 4