Publicité
Les langues disponibles
Les langues disponibles
Warning:
To reduce the risk of injury when using this mower lifter, it is recommended to always follow basic safety precautions. Read this
instruction before using this product and save it for future reference.
1.
FEATURES
- Maximum weight supported: 400kg
- Overall dimensions: 115 cm x 50 cm
- Lifting frame dimensions: 106 cm x 30 cm
- Lifting height range: 60 cm max
- Maximum lifting angle: 60°
2.
SAFETY INSTRUCTIONS
For a correct and secure application:
- Only use the lawn mower lifter for lifting operations.
- Don't let children use or play with the lawn mower lifter.
- Don't let anyone approach the load while using the lawn mower lifter.
- Don't leave the lawn mower lifter without supervision while it's being used.
- Don't use the lawn mower lifter beyond its capacity. Overload can damage the lawn mower lifter and/or cause a defect on the tool
which may result in physical injury or material damage.
- The lawn mower lifter has been conceived to be used on plain and hard surfaces. Using this tool on a soft surface can cause instability
of the lawn mower lifter and make the load fall down.
- Always fasten the load along the lateral reinforcement of the lawn mower lifter, which is on the opposite side of the lead screw. If the
load is not placed horizontally and not fastened, there is a risk, to damage the lawn mower lifter, as well for the load to slide and to fall
down.
- Before each utilization check the completeness and good functioning of the lawn mower lifter (make a test without load first).
- When lifting a riding lawn mower, check first that the driver has left his seat before lifting the mower.
- Turn off all engines and pull hand brake before using the lawn mower lifter.
- Do not slide your all body under the lawn mower when lifted.
3.
Assembly
4. Operation:
1.
Remove all the packing.
2.
Position the lifter on a level and stable surface.
3.
Remove the locking pin (3).
4.
Raise the lifting bars (5) to vertical position
5.
Raise the lead screw (2) and ensure the lugs on the
nut face left to right
6.
Replace the locking pin (3) in front of the lead screw.
1.
Assemble lifter as per assembly instructions
2.
Position the mower lifter on a flat level surface.
3.
Position the sit-on mover so the front or rear wheels
close to the lifting bars(5)
4.
Turn the handle (4) clockwise to raise the mower 2 to
3cm to ensure the right amount of balance is achieved
before continuing to lift. If the mower is unbalanced, turn
the handle anti-clockwise to return the mower to the
ground. Reposition the mower in between the lifting bars
and repeat the process.
5.
It is recommended that you position one or two jack
stands to support the lawn mower in case the lawn
mower lifter fail when in use.
6.
Turn the handle (4) anti-clockwise to lay down the
GB
Publicité
