Step 3: Driver Installation And Configuration For Windows Xp - Linksys Instant Wireless Serie Guide De Démarrage Rapide

Step 3: Driver Installation and
Configuration for Windows XP
After installing the PC Card in your computer, you will install the driver.
A. Windows XP will automatically detect the PC Card. Insert the Setup Wizard
CD-ROM into your CD-ROM drive. Click the radio button next to Install
the software automatically (Recommended). Then click Next.
A
B. When Windows has finished installing the driver, click Finish.
Note: Windows XP has a built-in configuration tool. Use Windows
XP Wireless Zero Configuration (located in the system tray at the
bottom of your screen) to configure the PC Card.
10
Instant Wireless Series
®
Wireless Network PC Card
C. A f t e r i n s t a l l i n g t h e P C C a r d, t h e Wi n d ow s X P Wi r e l e s s Z e r o
Configuration icon will appear in your computer's system tray. Double-
click the icon.
C
Note: Steps D and E are the instructions and screenshots for
Windows XP with Service Pack 1 installed. If you have not installed
Service Pack 1, select the network you want, and click the Connect
button. If the network has WEP encryption enabled, enter the WEP
key in the Network key field, and then click the Connect button.
D. The screen that appears will show any available wireless network. Select the
network you want.
If this network has WEP encryption enabled, go to Step E.
If this network does not
have WEP encryption
enabled, then the screen
in Figure D will appear.
Make sure the box next
to Allow me to connect
to the selected wireless
network, even though it
is not secure is
checked. Then click
Connect, and go to
Step F.
D
11