Linksys Instant Wireless Serie Guide De Démarrage Rapide page 38

DIREITOS DE AUTOR E MARCAS COMERCIAIS
As especificações estão sujeitas a alterações sem aviso prévio. Copyright © 2003
Linksys. Todos os direitos reservados. Instant Wireless, Linksys e o logótipo da Linksys
são marcas registadas do Linksys Group, Inc., Microsoft, Windows e o logótipo do
Windows são marcas registadas da Microsoft Corporation. Todas as outras marcas
comerciais e nomes de marcas são propriedade dos respectivos proprietários.
AVISOS DE SEGURANÇA E REGULAMENTAÇÃO
FCC STATEMENT
The Instant Wireless ® Wireless Network PC Card has been tested and complies with the
specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used according to the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which is found by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
Increase the separation between the equipment or devices
•
Connect the equipment to an outlet other than the receiver's
•
• Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution: Any change or modification to the product not expressly approved
by Linksys could void the user's authority to operate the device.
FCC RF Radiation Exposure Statement
To comply with the FCC and ANSI C95.1 RF exposure limits, the antenna(s) for this
device must comply with the following:
• Access points with 2.4 GHz or 5 GHz integrated antenna must operate with
a separation distance of at least 20 cm from all persons using the cable provided
and must not be co-located or operating in conjunction with any other antenna
or transmitter.
End-users must be provided with specific operations for satisfying RF exposure
compliance.
Note: Dual antennas used for diversity operation are not considered co-located.
72
Série Instant Wireless ® Placa PC Card para rede sem fios
Índice
Conteúdo da embalagem
Antes de começar
Passo 1: Instalação e configuração de software para
o Windows 98SE, Me e 2000
Passo 2: Ligar a placa PC Card para rede sem fios
Passo 3: Instalação e configuração de controladores
para o Windows XP
Para obter suporte técnico e efectuar o registo dos produtos, contacte-nos
através dos seguintes endereços:
Correio electrónico
Europa
América Latina
Web site
europe-support@linksys.com
latam-soporte@linksys.com
http://www.linksys.com/international
74
74
75
79
80
73