Publicité
Les langues disponibles
Les langues disponibles
A.
LAMP ASSEMBLY
Spare parts
English
B.
INSTALLATION/ REPLACEMENT OF BULB
Instructions before installing or replacing the bulb:
- The cable must be disconnected from the socket.
- Place the lamp on a flat, stable and non-slippery surface.
- If the lamp was lit before, allow the lamp and the bulb to cool for at
least 10 minutes before any operation.
Characteristics:
Lamp: 230V 50Hz
2 LED bulbs (12W max each, E27 - non
included)
to
be
installed
lampshade.
1 LED bulb (9W, E14 – not included) to be
installed
in
the
lamp
procedure below for installation.
1
Unscrew the small ball under the
lampbody. Remove the cover and take
out gently the bottom so as to see the
lampholder. Do not pull on the wires !
3
Screw the new one.
under
the
body.
See the
2
Unscrew the old bulb.
4
Replace the bottom into the lampbody,
put the cover and screw the small ball.
2
Publicité
