First Use - Karomat KD 900-150 Manuel D'instructions

or storm. Keep all connections dry and off the ground. Do not touch plug with
wet hands. It is strictly prohibited to let water leak into the machine.
▪ Never let the machine function for longer than 2 minutes when no water is
needed. The water in the machine then becomes too hot because of friction
and this can cause severe damage to the pump.
▪ Always use clean water (to a maximum of 50
blockage.
▪ When detergents have been used, flush the machine for several minutes with
clean water.
▪ After use of warm water, flush the machine with cold water for several minutes.
▪ Do not expose the machine to temperatures below 0
▪ Beware that the electricity cable is not damaged and do not repair temporarily.
Beware that plugs is always in a dry spot and never touch the plug with wet
hands.
▪ Do not open the machine while running or while connected to electricity.
▪ Always care for sufficient ventilation to avoid overheating.
▪ Never spray with full pressure at people or animals.
▪ After use sqeeze the trigger of the spouting gun one more time, to releave
pressure from the machine and the spouting gun.
▪ Always use original spare parts. Never use the machine if one of the parts is
damaged.
▪ WARNING: the warnings, cautions and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that
may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be
supplied by the operator.
▪ Only those persons who are aware of how to use the machine by having read
this manual, should use the machine. Injudicious use may cause danger.

5. FIRST USE

The Karömat KD 900-150 / KD 1100-200 is not delivered to you ready to use.
Before you start working with the machine, a number of measurements must be
taken.
1. Connect the high pressure hose to the spouting gun and to the high pressure
connection on the cleaner. Then connect the front part of the spouting gun to
the rear part.
2. Connect the watersupply hose to the waterconnection and your watersupply
tap.
3. Check wether there is enough oil in the pump. At a right oil level, the oil should
be above the red dot on the oilcheckglass at the pump
o
C.) to prevent the machine from
18
o
C.