Residual Heat Indication; Timer - HDC ELSA 302 Notice D'utilisation

Residual heat indication

After the switch off of a heating zone or the complete stop of the hob, the heating zones are still hot
and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
As far as the residual heat indicators are on light, don't touch the heating zones and don't put any
heat sensitive object on them. There are risks of burn and fire.

Timer

The timer is able to be used simultaneous with all heating zones and this with different time settings
(from 0 to 99 minutes) for each heating zone.
•
Setting and modification of the cooking time :
Action
Zone selection
Increase power
To select « Timer »
Decrease the time
Increase the time
After a few seconds the control light stops with blinking.
The time is confirmed and the cooking starts until the time reaches [ 00 ].
•
To stop the cooking time :
Action
Zone selection
To select « Timer »
To stop the « Timer »
If several timers are activated repeat the process.
•
Automatic stop at the end of the cooking time :
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press any key.
•
Egg timer function :
Action
Activate the hob
Select« Timer »
Decrease the time
Increase the time
After a few seconds the control light stops with blinking.
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press any key.
Control panel
Press selection zone key
Press key [ + ]
Press simultaneously [ - ] and [ + ]
Press key [ - ]
Press key [ + ]
Control panel
Press selection zone key
Press simultaneously [ - ] and [ + ]
Press key [ - ]
Control panel
Press key [ ]
Press simultaneously [ - ] and [ + ]
Press key [ - ]
Press key [ + ]
25
Display
[ 0 ]
[ 1 ] to [ 9 ]
Timer [ 00 ] min
[ 00 ] wents to 30,29...
time increase
Display
[ 0 ]
The remaining time
[ 00 ] then stops
Display
[ 0 ] or [ H ]
Timer [ 00 ] min
[ 00 ] wents to 30,29....
time increase