AGV K-3SV Mode D'emploi page 15

1
3
1
1
3
3.2) Removing/fitting the wind-proof chin
strap protection
To fit the fabric protector, mesh the teeth on the chin
guard with the edge of the base (1).
To remove the protector, slide it upwards and pull out
by one end.
2
4
3.3) Removing/Fitting the crown pad
To remove the crown pad, undo the buttons at the front
(1) then at the rear (2).
Reverse the process to fit the pad.
2
3.4) Removing/Fitting the air filter
Inside the bag containing the instructions, you will also
find a mesh to be fitted to the front opening on the
crown pad.
To filter the air entering the helmet, simply fasten the
mesh in place using the Velcro fasteners provided.
2
15