Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite CCT Selectable WallMax™ Open Face
®
Note: Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
Optional USB-C Controls Installation:
from attachment bolts.
1. Remove the two (2) screws securing the USB-C
mounting plate to the back plate.
Mounting Plate
3. Place the mounting plate into its original position
and secure with the two (2) screws removed in
step 1. The sensor should fit into the plastic lens
on the bottom of the fixture.
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
USB-C
2. Plug the USB-C sensor into the USB-C receptacle on
the mounting plate. Secure the sensor to the mounting
plate with the included screw.
USB-C
Sensor
4. Close the fixture and remove the bronze cover from
the bottom plastic lens. Refer to the remote instruction
manual for sensor programming.
WPOP Series
Bronze Cover
Page: 4
REV: 11/19/21
Publicité
