Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
MaxLite CCT Selectable WallMax™ Open Face
®
Note: Add a bead of exterior grade silicone sealant around the perimeter of the wall pack on the wall to inhibit any moisture
Installation & Operation - Junction Box Mounting:
from attachment bolts.
1. Unscrew the screws on the right side of the fixture
using a suitable Phillips screw driver. Separate the
male and female connectors connecting the driver
DC wires to the LEDs, then remove the reflector
from the back plate.
Reflector
Male
Connector
© Copyright 2021. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Female
Connector
2. Depending on the junction box (4" or 5"), drill four (4) 5.0mm holes in
locations indicated by A/B/C/D in the figure below to allow screws to
connect with the junction box. The purpose is to compress the
gasket not weight bearing holding the fixture to the wall. The 3
anchor bolts in # 4 are weight bearing to hold the fixture on the wall.
Unscrew the knockout (KO) plug from the center of the back plate.
A
B
Electric
Drill
Back Plate
E
D
Knockout (KO) Plug
C
F
G
WPOP Series
Page: 2
REV: 11/19/21
Publicité
