Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
1.
Open the housing by carefully pressing in the plastic clips at the
sides.
2.
Release the 3 screws and remove the PCB from the rear wall of the
unit.
3.
Use the rear of the hardwired expansion unit to draw the boreholes
at the required assembly location. Bore the appropriate holes and
insert the correct dowel pins into then.
4.
Insert the cable of the 4-wire BUS as well as the required cable from
the zones through the two larger holes on the rear of the module.
5.
Screw the rear of the housing with the correct screws onto the
required assembly location and re-insert the PCB.
6.
Make sure that the alarm centre is disconnected from the mains.
7.
Connect the 4-wire BUS and the zones correctly, depending on the
zone type.
8.
Once more close the 8-zone expansion module.
When putting into operation, the alarm centre automatically learns which
zones are additionally assigned by the expansion module.
10
Publicité
