ABUS Security-Center AZ5140 Instructions D'installation page 8

connector strip snap in under low pressure.
Maybe you have to flip the jack if it not snaps in.
The jack matches only in one position (see the
printed numbers at jack and strip).
4. Clip the 4 plastic feet on the bottom side of the
relay module to the holes at the corners.
5. Now connect the relay outputs in the wanted
connection mode NO (normally open) or NC
(normally closed) (FIG2).
6. Fit the relay module at a suitable position inside
the alarm panel.
Technical data
- 8 potential free relay outputs
- Contacts NC/NO
- Max. current/voltage 1A / 30 VDC
- Connected to the extra transistor strip
- incl. connection cable
4