Karaoke; Using A Microphone; External Equipment - Panasonic SC-UA3 Manuel Du Propriétaire

UA3PP_TQBJ2018_en.fm Page 12 Monday, May 15, 2017 9:58 AM

Karaoke

Preparation
Select the music source.
Note:
The Karaoke function is turned off when you turn off the
system.
Changing the Karaoke effect
You can use the Karaoke effect function to add the sound
effects.
1
Press [SOUND] repeatedly to select "KARAOKE
EFFECT".
2
Press [R, T] to select the effect.
VOCAL CANCEL Turn on or turn off the voice
guide (depending on the source).
ECHO Add echo effect to the sound.
KEY CONTROL Change the key of a song.
Note:
The setting is canceled when you
turn to another source.
TEMPO
CD USB
Change the speed of a song.
BGM Change the background music
level.
MIC EQ Select a MIC EQ mode.
OFF Cancel the effect.
To check the current setting, press [OK].
3
Press [2/3] or [5/6] to select the setting
and then press [OK].
Note:
To use the Karaoke effect in D-IN or AUX source, set "D-IN
MODE" or "AUX MODE" to "MODE 1".

Using a microphone

Preparation
Decrease the volume of the system to its minimum before
you connect or disconnect a microphone.
Rear panel
of this unit
Microphone
(not supplied)
1
Connect a microphone (not supplied) to the
microphone jack.
12
Plug type: Ø 6.3 mm (
1
12
( )
Zpage 13
/ ") monaural
4
digital printing
2
Press [SOUND] repeatedly to select "MIC VOL".
3
Press [R, T] to adjust the volume of the
microphone and then press [OK].
If you want to sing with the background music.
4
Play the music source and adjust the volume of
the system.
Note:
•
If a strange noise (howling) is emitted, move the
microphone away from the speakers, or decrease the
volume of the microphone.
• When you do not use the microphone, disconnect it from
the microphone jack, and decrease the volume of the
microphone to its minimum.

External equipment

Preparation
• Disconnect the AC power supply cord.
• Turn off all equipment and read the appropriate
operating instructions.
Note:
• Components and cables are sold separately.
• Sound distortion can occur when you use an adapter.
• If you want to connect equipment other than those
described, refer to the audio dealer.
Using the optical input
You can connect a TV, VCR, DVD player etc., and listen
to the audio through this system.
Rear panel
of this unit
Optical digital audio
cable (not supplied)
1
Connect the external equipment.
2
Press [RADIO/EXT-IN] repeatedly to select "D-IN".
3
Play the external equipment.
Note:
•
This system can only detect linear PCM signals.
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz,
up to 96 kHz.
• The sound is muted if the signal format or frequency is not
supported.
•
If there are sounds coming from the TV's speakers,
decrease the volume of the TV to its minimum.
TV (not supplied)