Sony MPK-DVF5 Mode D'emploi page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Preparations (continued)
Use the mounting shoe G only.
1 Attach the mounting shoe G firmly to the
2 Connect the A/V connecting cable of the shoe
3 Attach the battery adaptor that comes with
4 Attach the battery to the rear of the
Now you are ready to install the camcorder to the marine pack.
Be sure to check that the camera mounting shoe is attached to the camcorder tightly before
you install the camcorder to the marine pack.
6
Prepare to record.
1 Set the POWER switch to CAMERA.
2 Set COMMANDER to ON in the menu settings.
3 Cancel the following functions: BACK LIGHT, NIGHTSHOT, Nightshot plus, PROGRAM
4 Set the FOCUS switch to AUTO.
5 Set DISPLAY to V-OUT/LCD in the menu settings and press the DISPLAY button on your
*
8
-GB
For DCR-PC109/PC109E/PC108/
PC108E/PC107/PC107E/PC106E
camcorder.
to the camcorder's A/V jack.
the mounting shoe G to battery terminal of
the camcorder.
If there is a battery installed in the
camcorder, remove it.
mounting shoe G A.
Fasten the battery firmly with the belt, as
shown in the illustration.
AE, flash, Picture effect and TELE MACRO.
camcorder before installing the marine pack.
If your camcorder has REC LAMP in the menu settings, set it to OFF. By using this function,
the light of the lamp is not reflected in the lens. For details, please refer to the operating
instructions supplied with your camcorder.
Camera
mounting
shoe G
A

Publicité

Table des Matières
loading

Table des Matières