Guide For Setting Of Reaction Distance - Schülke touchless D1 Manuel D'emploi

Guide for setting of reaction distance

1
Take out control box, open battery box and put the four batteries in it. Do not close the battery box. (see picture 1).
2
Press start switch button and dosage button at the same time by one hand (see picture 2) and close the cover of battery box with the
other hand. Then you can see a flashing red/ blue LED light (see picture 4).
Noted: Please close battery case before taking your hand off from start switch and dosage button.
3
3. Pick out a piece of paper on which you draw two parallel lines with a distance of 9 cm (ideal reaction distance) (see picture 5). Then put
the semi-finished product aside one line on the side of the left hand (see picture 6) and your hand on the other line (Noted: put your hand
vertically and straightly. see picture 7). Move your hand parallel to the sensor's direction and you'll see red/blue light sparkles very fast.
Press the dosage button again to confirm the distance (see picture 7). When the red/ blue light changes into red, it indicates that the
distance between the sensor and you hand is fixed. If you want the distance to be longer, put your hand further away. If you want it to be
shorter, just put your hand closer to the control box.
Photo 1
LED has red/ blue light
Photo 4
Press the dosage
Photo 7
hand in right way
touchless D1 Instruction manual for a Electric Dispenser · www.schuelke.com
Photo 2
Photo 5
Photo 8
button after
putting your
Press start switch
Press the
dosage button
Photo 3
Photo 6
The red light will be
flashed when you
press down the dosage
button.
Close the battery case
when pressing start
switch and the dosage
button.
Page 7 of 42
EN
DE
FR
IT
NL