Publicité
Les langues disponibles
Les langues disponibles
Proceed as follows:
Select the lights for which the code assignment is to be deleted. Turn off the power
for at least 3 seconds. Press the "All ON" button
and then turn the power on again.
The lights will flash six times to confirm the successful deletion of the code assignment.
Then the lights can be regrouped as described in step 1.
3. Switching function for light colours:
The
button switches the light colours one after the other. When this button is
pressed and held, all lights change the light colours in the sequence
white-yellow-neutral, namely at 100% brightness.
4. 100% brightness:
Press and hold the
button until all lights reach 100% brightness. Press and hold
the "Group ON" button to set the brightness of all light in this group to 100%.
5.
Power off button:
Press the
button; all lights will be switched off. Press die "Group OFF" button; all
lights in this group will be switched off at the same time.
6. Night light function:
Press the night light button
; all lights will be switched to night light mode; press and
hold the "Group OFF" button; all lights in a group will be switched to night light mode.
The brightness in night light mode is 8% of the maximum brightness.
7. Dimming function and function to set the colour temperature:
As shown in fig. 1, press the left side of the button and the light will gradually change to
a warm colour. Press the right side of the button and the light will gradually change to a
cold colour. Press the top of the button and the light gradually becomes brighter; press
the bottom of the button and the light gradually becomes darker.
WOFI LEUCHTEN
Wortmann & Filz GmbH . Im Langel 6 . D-59872 Meschede
+49/(0)2903-449 449
+49/(0)2903 - 449 459
service@wofi.de
www.wofi.de
Publicité
