Using Audio/ Video Input Jacks - Sanyo AVM-3259S Manuel D'instructions

USING THE AUDIO/ VIDEO INPUT JACKS
CONNECTING A VCR OR OTHER EXTERNAL EQUIPMENT
Switch off TV and external equipment before connecting cables.
1. Connect VCR, DVD, DSS, or other equipment's Audio Out (R/L) to the TV Audio
Input (R/L) .
For Mono VCR (Single Audio Jack) connect VCR Audio Out to TV Audio (L) Input.
2. Connect VCR, DVD, DSS, or other equipment's Video Out to the TV Video Input
Optional
Connect VCR, DVD, DSS, or other equipment's S-Video Out to the TV S-Video In Jack
Using the S-Video In jack overrides the Video 1 jack
3. Press POWER to turn on the TV. See
4. Press the VIDEO MODE key
equipment you have connected to the A/V1 and A/V2 jacks. See page 6 for remote control
.
operation
Follow the same procedure to connect other compatible video equipment to the second set
of A/V jacks.
IN
RF
CHANNEL
CH3 CH4
OUT
UHF/VHF/CATV
75Ω
AUDIO
VIDEO
INPUT
1
AUDIO
VIDEO
INPUT
2
.
Turn on external equipment also.
to select program source: TV signal or signal from the
A/V JACKS
R- AUDIO -L VIDEO
R- AUDIO -L VIDEO
Back View
of a VCR
S-VIDEO
AUDIO
(MONO)
OUTPUT
AUDIO VIDEO
R L
L
R
AUDIO VIDEO
R L
(MONO)
TV A/V Input
Rear Jacks
.
VCR TV
VIDEO
POWER
MODE
1
Remote Control
DVD Player
QuickTips
Make sure all cable
connectors are fully
seated on jacks.
.
Always match cables
according to the
colors;
RED
.
audio,
WHITE
audio and
for video.
A/V1 and A/V2 jacks
have identical func-
tions. Any
compatible video
equipment can be
connected to either
set of jacks.
A solid Blue screen
with the word
Video1 or Video2
CABLE
displayed means
that the Video mode
RESET
is selected, but no
2 3
signal is being
detected at the
Video jack. Check
connection, and
turn on external
equipment.
Make sure you select
TV channel to match
your VCR output
(Ch. 3 or 4).
You may be able
to use the remote
control to operate
your VCR, Cable
Box and TV.
(See page 7.)
for right
for left
YELLOW
11