Assembly And Installation; Safety; Supply Connections; Assembly - GIFAS ELECTRIC AlphaLUXX-AC 120 Mode D'emploi

Operating Instructions for AlphaLUXX-AC 120 / 100 / 80

3 Assembly and installation

3.1

Safety

If the AlphaLUXX exhibits mechanical damage (faulty cables or plugs, cracks, etc.) or electrical defects, it must
be taken out of use immediately. The current national guidelines regarding periodic checks apply.
Hint
To avoid danger, any damaged external flexible cable on these lights must be replaced only by the manufac-
turer, its service representative or a similarly qualified professional.
3.2

Supply connections

Connection to connecting cable with 3 conductors, coloured wires:
Wire colour brown
Wire colour blue
Wire colour yellow/green
Hint
To ensure protection against leaks, the enclosed screw must be screwed in tightly. According to the TEE-
®
TUBE screw fixing manufacturer's information, it must be tightened to a torque of 2.5 Nm.
This must be safeguarded using suitable measures at installation sites where the connecting cable is subjected
to particular mechanical stress.
No liability can be accepted for connections that are not established correctly (not completely tight).
Fault-current circuit breakers must not trip because type "A" and surge current strength 3kA type G pursuant
to IEC 61008 can be regarded as the standard for lighting.
3.3

Assembly

Hint
By default, the AlphaLUXX is supplied with a mounting bracket that is suitable for wall and ceiling mounting.
The AlphaLUXX spotlight must only be installed using the mounting bracket supplied!
The hole spacings can be taken from the drawing under 2.1.1.
Choose fastening materials appropriate for the weight and secure screws to prevent them working themselves
loose if necessary.
Created Edited
27/01/2016 11/04/2017
A.S. A.S.
= L
= N
= PE
Object ID
....
®
TEETUBE screw fixing:
Page 21 / 46