Getting Started; Step 1: Preparing A Power Source - Sony IC RECORDER ICD-SX700 Guide De Démarrage Rapide

Getting Started

Step 1: Preparing a
Power Source
Remove the film on the display window
before you use the IC recorder.
Inserting the batteries
1
Slide and lift the battery
compartment lid.
2
Insert two NH-AAA rechargeable
batteries with correct polarity, and
close the lid.
3
Charge the batteries by connecting
the (USB) connector of the IC
recorder to your computer.
Disconnecting the IC
recorder from your
computer
Follow the procedures below; otherwise,
data may be damaged.
1
Make sure that the operation
indicator is not flashing.
2
Disconnect the USB connecting
cable connected to the IC recorder
from the USB connector of the
computer.
On the Windows screen, left-click
"Safely Remove Hardware" on the
taskbar, and click "Safely remove USB
Mass Storage Device. "
On the Macintosh screen, drag the "IC
RECORDER" on the desktop to "Trash"
and drop it there.
For details on disconnecting the
IC recorder, refer to the operating
instructions supplied with your
computer.