Publicité
Les langues disponibles
Les langues disponibles
Handling:
1.
Remove mini foot pump from the packaging
2.
How to pump up objects.
2.1
Adjust pumphead to selected valve type (see figs.last page). .
2.1.1
Close clamping lever by turning it upward
2.1.2
Analog gauge start pumping. Digital gauge turn on first. After 60 seconds the
gauge switches off automatically. ( Spare battery: part no. 1004.07 )
2.1.3
Fold down foot stand (B)(see fig.) from piston of pressure cylinder (C)
(see fig.) and place mini foot pump on ground.
2.4
Pump up object to the prescribed pressure (as indicated on tyre).
Note:
Place the mini foot pump on a even surface. Always use the full stroke
capacity of the piston!
Variations on the gauge during pumping are normal.
If pressure should drop while pumping, check if the pumphead has become
loose.
3.
Disconnect pumphead (F) (see fig.) from valve.
4.
Push piston of the mini foot pump all the way into the pressure cylinder (C)
(see fig.) and fold up foot stand (B) (see fig.).
5.
Put mini foot pump back into the nylon bag. Bag stored in the bottom of
packaging
6.
Shot off valve to high pressure:
Use the high volume mode (orange pedal at bottom) to pump up large air
volume into the tyre. Should the pump resistance become too high, change to
high-pressure mode (press orange pedal strongly upward, see drawing on
pump) to obtain the max. pressure of 12 bar.
change shot off valve to high pressure
after riched 40 psi/ 3 bar
Mini foot pump
Instruction Manual
5
Publicité
