Publicité
Les langues disponibles
Les langues disponibles
Typical Mounting Instructions For Workboard Faucets
GENERAL INSTRUCTIONS:
Most faucets are supplied with mounting hardware,
including ½" nipples. For installation instructions, we
will assume that hot and cold water supplies end in ½"
nipples. We recommend using a 1
/
" hole in the deck
1
4
or backsplash to accommodate the ½" supply nipples.
1. Turn off water supply at main source.
2. Hand-tighten all parts prior to tightening with wrench.
3. Do not force parts together.
4. All plated surfaces should be handled with care;
avoid scratching with tools.
5. Dimensions shown are for reference only and not to
be used for pre-plumbing.
6. Use teflon tape or pipe joint compound when making
threaded connections to water supply lines.
INSTALLATION INSTRUCTIONS:
1. Rigid Spout: Thread into opening on faucet body and
tighten spout into body. Swivel Spout: Push swivel
spout into threaded opening on faucet body and tighten
spout nut to body.
2. Using plumber's putty, run a thick bead of putty on the
underside of faucet body around perimeter and shanks.
3. Deck Mount: Insert faucet body into mounting holes in
deck. Back Splash: Insert faucet body into backsplash.
4. Using mounting kit provided, tighten faucet shanks to
deck or backsplash and scrape excess putty away
from body. Install mounting hardware in the following
order: rubber washer, metal lock washer, lock nut.
5. Connect water supply line to faucet shanks.
6. Turn on water supply and check for leaks.
MOUNTING KIT:
WASHER
1/2" NPSM COUPLING NUT & SEAL
LOCKING WASHER
FOR 1/2" RIGID OR FLEXIBLE RISER
LOCKING NUT
SPOUT NUT
FAUCET BODY
WARNING
!
Read this Manual BEFORE using this equipment.
Failure to read and follow all safety and use information can result in death,
serious personal injury, property damage, or damage to the equipment.
Keep this Manual for future reference.
For additional information on replacements parts,
please visit our website: foodservice.watts.com
SPOUT NUT
FAUCET BODY
MOUNTING KIT:
WASHER
LOCKING WASHER
LOCKING NUT
1/2" NPSM
Publicité
