Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
4
This towbar is designed to assembly in following cars:
KIA RIO II, 5 doors, produced since 08.2005 till 09.2009, catalogue no.
T50A and is prepared to tow trailers max total weight 1100 kg and max
vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
1
3
From manufacturer
1. Disassemble the bumper.
2. Apply the main bar of the towbar (pos. 1) to the chassis
4
of the car into such way that holes of the towbar be
covered with threaded holes in chassis members and fix
using bolts M12x1,25x40mm (pos. 4) from the towbar
accessories.
3. Install the bumper.
4. Fix body of the automat and place tow-ball according to
supplied instruction. Note! Remember to place socket
plate (pos. 3) as shown on the drawing 1.
5. Tighten all bolts according to the torque shown in the
table.
6. Connect electric wires of 7-poles socket according to
the instruction of the car. (Recommend to make at
authorized service station).
7. Complete paint layer damaged during installation.
2
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in
registration book (at authorised service station).The car should
be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball
of towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm
Publicité
