Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
12
9
12
B
10
A
B
A
5
12
7
11
This towing hitch is designed to assembly in following cars:
HONDA CIVIC, 5 doors, except 2.0i Sport, produced since 03.2001 till
12.2005, catalogue no. Y20A and is prepared to tow trailers max total weight
1200 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
8
12
B
A
4
A
1
3
From manufacturer
12
B
10
Fig. 2 Bumper cut out
11
1.
Disassemble a bumper, muffler and metal reinforcement (not used any more) and take
out side and rear covers inside the trunk.
12
2.
In bottom part of the bumper cut out fragment according to figure 2.
3.
On protruding pins in rear wall of car body put left handle (pos. 7) on the left side and
right handle (pos. 6) on the right side and fix using original nuts M8 from metal
11
reinforcement disassembly and per one bolt M10x35mm (pos. 12) from accessories
(fix loosely).
6
4.
With in this way prepared elements fix side brackets (pos. 4 and 5) and main bar of
the towing hitch pos. 1 using bolts M12x40mm (pos. 11) – see drawing.
Through holes pos. A of side brackets drill holes ø11mm, straight through.
5.
6.
Inside the trunk put fish-plates (pos. 8 and 9) in this way, so holes of the fish-plates
agree with holes drilled before and fix loosely using bolts M10x35mm (pos. 12).
Through holes pos. B of fish-plates drill straight through holes ø11mm and next fix
7.
with rectangular washer (pos. 10) by bolts M10x35mm (pos. 12).
8.
Reassemble the bumper and the muffler.
9.
Fix body of the automat and place tow-ball according to supplied instruction. Note!
Remember to place socket plate (pos. 3) as shown on the drawing 1.
10. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
11.
Complete paint layer damaged during installation
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts. The ball of towing hitch must be always kept clear
and conserve with a grease.
The instruction of the assembly
.
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE
Publicité
