AUTO-HAK Y32 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
Bolts M8
M12x35
Washer
ø35xø13x3mm
This towbar is designed to assembly in following cars:
HONDA CIVIC, 5 doors, produced since 2006, catalogue no. Y32 and is
prepared to tow trailers max total weight 1500 kg and max vertical load
75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
ø35xø13x3mm
Bolts M8
Washer
ø35xø13x3mm
M12x35
1
M12x75
3
From manufacturer
1. For the purpose of installings of the towbar one ought to disassemble the
bumper.
Washer
2. Unscrew the metal reinforcement (will not be assembled again).
3. Slip the main bar of the towbar (pos. 1) to chassis members and fix using
bolts M12x35mm (pos. 5) and bolts M8 remaining by unscrewing of the
metal reinforcement (see fig. 1).
4. Cut out the fragment of the bumper in the bottom part of the bumper – (see
fig. 2).
M12x35
5. Tighten all bolts according to the torque shown in the table.
6. Install the bumper.
7. Fix tow-ball (pos. 2) with socket plate (pos. 3) using bolts M12x75mm (pos.
4) from accessories.
2
8. Connect electric wires of 7-poles socket according to the instruction of the
car. (Recommend to make at authorized service station).
9. Complete paint layer damaged during installation.
Fig. 1
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Fig. 2