Rointe ELBA OVAL Manuel D'installation Et D'utilisation page 13

An installation kit is included in the packaging. Follow the instructions below:
1. Select the appropriate location on the wall.
2. Place the template on the wall, making small marks where the holes are to be located.
3. Remove the template and drill the holes.
4. Insert the plugs into the holes made.
5. Screw the plastic anchoring piece to the wall with the screw Ø 5.5 x 50 mm.
6. Screw the two towel rail fastening pieces and the plastic fastening piece to the horizontal
tube of the towel rail as shown in the figure below with the screw Ø 6 x 35 mm.
7. Insert the assembly from point 6 into the plastic anchoring piece and fasten with the Ø
2.9 x 9.5 mm grub screw.
8. Fit the trim on the cable clamp.
Nº.
1 Rawl Plug Ø10 x 45 mm
2 Fixed plastic bracket
3 Screw Ø 5.5 x 50 mm
4 Plastic bracket with nut M6
5 Plastic head support
6 Screw Ø 6 x 35 mm
7 Plastic cover support
8 Locking screw Ø 2.9 x 9.5 mm
9 Product
ITEM
ELBA OVAL ELECTRIC TOWEL RAIL
EN
13