Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
4
3
This towbar is designed to assembly in following cars:
HYUNDAI ACCENT 3/5 doors (LC, HC), produced since 01.2000 till
11.2005, catalogue no. J14A and is prepared to tow trailers max total
weight 1100 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right opera-
tion. For this reasons we kindly ask to read carefully this instruction and apply to
hints.
The towbar should be install in points described by a car producer.
1
From manufacturer
1. Apply the main bar of the towbar (pos. 1) to the frame of the
4
car and through holes (pos. A) fix it using bolts
M12x1,25x35mm – pos. 4 (loosely).
2. Fix body of the automat and place tow-ball according to sup-
plied instruction. Note! Remember to place socket plate
(pos. 3) as shown on the drawing 1.
3. Tighten all bolts according to the torque shown in the table.
4. Connect electric wires of 7-poles socket according to the in-
struction of the car. (Recommend to make at authorized ser-
vice station).
5. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registra-
tion book (at authorised service station).The car should be
equipped with:
Indicators
Tow mirrors
Check all bolts and nuts after 1000km of exploitation. The ball
of towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE
Publicité
