Publicité
Les langues disponibles
Les langues disponibles
ATTAcH lANDiNG PADs
Refer to the fit chart on page 5 (or online at
YAKIMA.COM if your vehicle is not listed) to
determine the correct hardware for your vehicle.
a) Put landing Pad in place on a clean and dry rooftop.
b) stack metal washer on top of plastic washer with convex side of plastic
washer facing down. add washers as needed to prevent bolt from
bottoming out.
c) Put fastener through washers, through landing Pad, and thread into
threaded mounting point in rooftop.
D) T hread the fastener, and tighten with short handle as shown, but do not
fully tighten. Use caution not to cross thread fastener.
e) Jostle and rotate landing pad in all directions to ensure plastic washer is
fully seated, and if necessary re-tighten to remove any play.
• Repeat for second Landing Pad.
A
1033512D-3/24
M6 hardware
B
Convex side
down.
BE suRE To usE THE coRREcT
lENGTH oF HARDWARE!
M8 hardware
WARNiNG: Do NoT AlloW
EDGEs oF PAD To cuRl uNDER!
C
D
NOTE: Final tightening will happen in the next step.
E
Publicité
