Publicité
Les langues disponibles
Les langues disponibles
General instructions and directions
• The installation of the HL2 Wall must be carried out by a skilled person employed by a dealer recognized by Harrie Leenders
Haardkachels.
• The casing parts are susceptible to scratching. Handle them gently.
• After the stove has been properly installed, burn some kindling wood to check the draught.
Safety recommendations
• Glass tends to break easily, and broken glass is quite sharp. Take therefore adequate safety precautions.
• For general safety, we refer to guidelines or regulations issued by a relevant official body.
Materials and tools required
• Handtruck
• Open-end wrench, jaw width 13
• Spirit level
• 4 xpansion-shell bolts, 4 stucco screws (included)
• Screwdriver
• Flat tape (included)
• Masonry bit 8 and 14 mm
• Flue pipe
• 5 mm socket-head wrench
• Clamping strip
1. Moving the stove
•
Place the stove with its back against the hand truck.
•
Move the stove on the hand truck to the place of installation
desired.
32
2. Wall bracket
• Determine the height desired of the bottom of the stove; recom-
mended height = 300 mm, the top hole of the wall bracket will
then be 780 mm above the floor.
• Mark off the holes to be drilled. Centre of wall bracket corres-
ponds to centre of stove pipe.
• First dril the holes using an 8 mm masonry bit, then re-dril the
holes using a 14 mm masonry bit.
self-adhesive
tape
3. Wall bracket
• Use the expansion shells with hexagon socket bolts supplied to
fix the wall bracket to the wall.
• Affix two strips of flat self-adhesive tape on the vertical strips of
the wall bracket.
5. Connecting the pipe
•
Make the pipe to size and connect it using the appropriate
fastening materials.
•
Top-connected stove pipe: Leavc a 50 mm gap between the
underside of the pipe and the upper side of the connection ring
of the stove.
•
The figure shows the top-connected stove pipe. This also
applies to the rear-connected stove pipe.
adjustment bolts
4. Hanging the stove
• Hang the stove with the slotted holes of the convection wall on the
hooks of the wall bracket.
• Level the stove using the adjustment bolts provided at the lower part
of the wall bracket.
clamping
strip
6. Clamping the pipe
•
Fix the clamping strip
33
Publicité
