AUTO-HAK J50 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
9 6
10
5
6
This towbar is designed to assembly in following cars:
HYUNDAI SONATA, 4 doors (EM, EF), produced since 06.2001 till
02.2005, catalogue no. J50 and is prepared to tow trailers max total weight
1700 kg and max vertical load 75 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
9
6
1
10
4
17
2
3
1. Disassemble a rear bumper and his fulfillment, inclusive of brackets and
central support (not used any more).
2. Fix fulfillment of the bumper (with brackets) to the main bar of the
towbar (pos. 1) using bolts M8x30mm (pos. 6).
3. All unit put to the chassis members and fix using bolts M10x40mm
(pos. 5).
10
4. Underneath the bumper cut fragment acc. to figure 2.
Fig. 2
5. Reassemble the bumper.
6. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm
(pos. 4) from accessories.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station)
9. Complete paint layer damaged during installation.
Torque settings for nuts and bolts (8,8):
M 8
M 12 85 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
Assemble instruction
25 Nm M 10 55 Nm
M 14 135 Nm
NOTE