Placement; Safety Measures From Standpoint Of The Fire Protection Act. No. Čsn 061008 Coll. 12; Connection Of The Electric Cable To Electricity - cookmax FP 36 Mode D'emploi

The appliance may only be installed in permanently ventilated rooms, as specified by the standard ČSN
127040 and ČSN 127010. In the room where the appliance is installed, there must be an adequate air flow
to meet the requirements of normal combustion of gas and the necessary ventilation of the room itself. The
room must be kept adequately ventilated in order to eliminate the heat and humidity produced by cooking:
in particular, after prolonged use, it is recommended to open window or to increase the speed of ventilators.
Extract the device and check whether it was not damaged during transport. Settle the appliance down on
horizontal surface (max. allowed imbalance 2 °C).
If the device will be situated close to the wall, or if it will be in contact with the furniture walls, those walls
must resist temperatures ranging to 60°C. Installation, settings, putting into operation must be made by
qualified technician who is competent for this.
The device can be installed separately or in a set with other devices from our production. Minimal distance
10 cm from other subject must be kept.
Safety measures from standpoint of the fire protection Act. No. ČSN 061008 coll. 12
• The appliance is designed for use by adults
• Appliance may be safely used in a normal environment by Act No. ČSN 332000-1
• Appliance must be placed so as to stand on the non combustible surfaces
No subjects from combustible materials can be placed directly on the device or in distance which is shorter
than safety distance (the shortest allowed distance is 10 cm).
See Tab: combustion degree of building materials classified according to the combustion degree of
materials and product Act No. (ČSN 730823)
A – non combustible
B – uneasily combustible
C1 – hardly combustible
C2 – middle combustible
C3 – easily combustible
Appliances must be installed in a safe way. When installing you must respect corresponding project, safety
and hygienic orders according to:
•Act No. ČSN 06 1008 fire protection of local device and sources of heat
•Act No. ČSN 33 2000 environment for electric devices
Before you start, make sure that the voltage and capacity of the power line conform to the data shown on the
identification plate located on the side of the device. The appliance must be connected to earth in
compliance with electrical system safety regulations.

Placement

Granite, sandstone, concretes, bricks, ceramic, wall facing tiles
acumen, Heraclites, lihnos, itavere
Leafy wood, plywood, sirkoklit, rare paper, Formica
fibreboards, solodure, cork boards, rubber, floor- coverings
Wood-fibreboards, polystyrene, polyurethane, PVC

Connection of the electric cable to electricity

6