BELLOTA EPR132P Guide De L'utilisateur page 44

CHANGE THE TYPE OF CUT: PROGRESSIVE CUT –PULSE CUT
By default the progressive cut mode is activated. The progressive cut favours a touch-sensitive cut with
more control. The pulse cut makes cutting quicker, but there is less control:
1. Squeeze the trigger with the shears turned off, keep squeezing the trigger and press the power button.
2. You will hear 2 beeps; wait 16 seconds until you hear the 3rd beep.
3. The cutting mode has now been changed.
4. Repeat this operation whenever you want to change the cutting mode again.
CHANGING THE OPENING
1. Turn the shears on.
2. Squeeze the trigger twice to activate the shears.
3. Keep squeezing the trigger for 2 seconds until you hear the beep.
4. The opening has now been changed.
5. Repeat this operation whenever you want to change the opening.
It is important to adapt the opening of the blades to the diameter of the branch you want to cut. When the
branch is small in diameter, adapt the small opening for faster cuts. It will also save battery life.
CUT PREVENTION SAFETY SYSTEM
1. Turn the shears on and keep pressing the power button.
2. You will hear 2 beeps; wait 6 seconds until you hear the 3rd beep.
3. The system will be activated.
4. Repeat this operation to disable it.
CAUTION: Given the nature of the Cut-Prevention System, due to electrical conductivity, this system may
not function correctly under certain conditions:
•
Use of gloves
•
Poor conductivity in the user
•
Contact with a person other than the one operating the pruner
•
Dry skin, calluses
The cut prevention system can be useful to avoid more serious consequences in the event of an accident.
Bellota is not responsible for possible consequences or injuries that may occur in the unlikely event of
system failure or malfunction.
44