Datalogic Magellan 1100i Guide De Référence Rapide page 7

The scanner will not read bar codes while the button is pressed.
Targeted Scanning Mode will read bar codes in any orientation.
The scanner will return to full pattern Omni Mode after a con-
figurable time has elapsed.
NOTE
Troubleshooting
If the scanner is not operating properly, the following checks
should be performed:
1. If the scanner uses an external power supply and the exter-
nal power supply has failed, the scanner will not operate.
Exchange the power supply with a known good power sup-
ply and retest operation.
1
2. Verify the interface cable is securely attached to the host.
Consult your technical support personnel or refer to your
host system manual to verify the proper connection for the
scanner.
3. Verify that the interface cable is securely attached to the
scanner.
4. Check that the bar codes are of sufficient quality to be recog-
nized by the scanner. Wrinkled, smudged, or torn labels can
cause the scanner to not read at all. Scan known-good labels
of an active symbology
tion.
1. Reading of the various bar code symbologies can be independently enabled
or disabled in the scanner.
Quick Reference Guide
2
3
1
to check the scanner' s read opera-
4
5
3