EarthWise SN74016 Manuel Du Propriétaire page 8

Wheel bracket (Fig. 1E)
Align the holes on the wheel bracket with the holes on
the upper cover. Secure into place with ST3.9x45 Philips
head self tapping screws in the two (2) top holes and the
ST3.9x55 Philips head self tapping screws in the two (2)
bottom holes.
This snow thrower is intended to be used to sweep snow
from sidewalks, steps, patios, decks and other hard flat
surfaces such as paved driveways. Use it only on hard,
flat surfaces free of sand, stone and debris, wires or any
other objects. The manufacturer is not liable for any
damage or injury resulting from misuse.
Install battery
Open the battery compartment cover and slide the
battery down until it clicks to lock it into position, then
close the battery department cover (Fig. 3)
ASSEMBLY
Auxiliary handle (Fig. 2)
Position the auxiliary handle so that the holes are in
alignment with the holes in the handle support bracket.
Insert the M6X50 hex head bolt into the hex shaped bolt
hole of the bracket. Secure by tightening the wing nut
onto the bolt.
Loosen the wing nut and adjust the angle and height of
the handle to a safe and comfortable position. Secure
into place by tightening the wing nut onto the bolt.
2
OPERATING
3
8
Model SN74016
M6x50 Hex
Head Bolt