AUTO-HAK W07 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
1
5
5
This towing hitch is designed to assembly in following cars:
SUZUKI VITARA, 3 doors, produced since 1988 till 2001, catalogue no.
W07 and is prepared to tow trailers max total weight 1500 kg and max
vertical mass 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
5
6
3
From manufacturer
1. For the purpose of intallings of the towing hitch one ought to
unscrew factory-made towing eye. This towing eye will not be
A
used any more.
2. Apply the main bar of the towing hitch (pos. 1) from the bottom
of the car to its frame and trough holes A of the towing hitch and
existing in the frame threaded holeses fix using bolts
M12x1,25x30mm (pos. 5) from the towing hitch accessories.
3. To so installed bar of the towing hitch (pos. 1) fix tow ball (pos.
2) using bolts M16x50mm (pos. 4).
4. Fix the socket plate (pos. 3) as shown on the drawing using bolt
M10x30mm (pos. 6).
5
5. Tighten all bolts according to the torque shown in the table.
6. Connect electric wires of 7-poles socket according to the
2
instruction of the car. (Recommend to make at authorized service
station).
7. Complete paint layer damaged during installation.
4
M6 - 11 Nm
M12 - 87 Nm
After install the towing hitch you should get adequate note in
registration book (at authorised service station). The car should be
equipped with:
• Indicators
• Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must
be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm