AUTO-HAK X07 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
4
B
11
11 10
This towbar is designed to assembly in following cars:
DAEWOO NUBIRA ESTATE (100), produced since 06.1997 till
06.1999, catalogue no. X07 and is prepared to tow trailers max total weight
1200 kg and max vertical mass 70 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be installing in points described by a car producer.
5
8
11
1
9a
9b
12 3
From manufacturer
1. For the purpose of installing of the towbar one ought to disassemble the
bumper
A
of the bumper (both these parts will not be fastened again).
2. Unscrew fuel pump from on the right side of the vehicle (protect against
the damage).
3. Side brackets (pos. 4 and 5) put into chassis members and screw using
B
bolts M10x30mm (pos. 11) through the holes (pos. A) – use round
washers (pos. 8) from the towbar accessories.
4. By holes (pos. B) fix using bolts M10x100mm, this bolts are from
metal part of the bumper disassembly.
5. Across two sleeves L=10mm (pos. 7) from the towbar accessories screw
on previously opened fuel pump.
6. To installed brackets screw the main bar of the towbar (pos. 1) by bolts
10
M12x35mm (pos. 10).
7. To the main bar of the towbar (pos. 1) into the suitable manner screw on
6
four handles (pos. 6) from the towbar accessories.
8. Fix bumper (use handles of the towbar).
9. To so prepared towbar fix tow-ball (pos. 2) and socket plate (pos. 3) by
bolts M12x75mm (pos. 9a) and M12x70mm (pos. 9b) from accessories.
10. Tighten all bolts according to the torque shown in the table.
11. Connect electric wires of 7-poles socket according to the instruction of the
car. (Recommend to make at authorized service station).
2
12. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
, next metal part of fastening of the bumper and soft fulfillment
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE