Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
9
7
A
1
A
5
10
This towbar is designed to assembly in following cars:
IVECO DAILY metal build-up, loading platform, produced since 1989
till 04.1999, catalogue number R13 and is prepared to tow trailers max total
weight 3000 kg and max vertical load 100 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be installing in points described by a car producer.
9
6
A
10
3
From manufacturer
1. Put angle fish-plates (pos. 6 and 7) on the left and right side to the
chassis frame in this way, so holes in fish-plates agree with existing
holes in the frame.
2. Put side brackets (pos. 4 and 5) underneath the frame and fix with fish-
plates (pos. 6 and 7) through holes pos. A and through holes in the
frame using bolts M12x35mm (pos. 9).
4
3. Through original holes in the frame of chassis drill holes ø11mm in
side wall of fish-plates (pos. 6 and 7). Then fix it to the frame using
bolts M10x30mm (pos. 10)-drilled holes did not shown on the drawing.
10
4. Between mounted side brackets put main bar of the towbar (pos. 1) and
fix using bolts M10x30mm (pos. 10).
5. Fix tow-ball (pos. 2) using bolts M16x50mm (pos. 8) from accessories.
NOTE: In dependence of model use agreeable holes in main bar in this
way so tow-ball are in correct distance from the car.
6. Fix socket plate (pos. 3) using bolt M10x30mm (pos. 10) as shown on
the figure.
7. Tighten all bolts according to the torque shown in the table.
2
8. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station).
9. Complete paint layer damaged during installation.
8
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
Check all bolts and nuts after 1000 km of exploitation. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm
M14 - 138 Nm
NOTE
M10 - 50 Nm
M16 - 210 Nm
Publicité
