AUTO-HAK X17A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
5
4
9
A
This towbar is designed to assembly in following cars:
CHEVROLET LACETTI 5 doors, produced since 01.2005, catalogue
no. X17A and is prepared to tow trailers max total weight 1200 kg and max
vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
1
3
From manufacturer
1. Disassemble a rear bumper.
4
2. Unscrew reinforcement of the bumper, next unscrew fastening handles.
A
3. Reinforcement fix to the main bar of the towbar (pos. 1) in points pos.
A.
4. Put towbar to chassis members and fix using bolts from towbar
equipment – see figure.
5. Fix body of the automat according to supplied instruction.
9
6. Fix the socket plate (pos. 3) as shown on the drawing.
7. Tighten all bolts according to the torque shown in the table.
13
8. Connect electric wires of 7-poles socket according to the instruction of
11
the car. (Recommend to make at authorized service station)
9. Complete paint layer damaged during installation.
8
2
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 25 Nm M 10 55 Nm
M 12 85 Nm M 14 135 Nm
NOTE