Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
WARNING: READ THIS MANUAL CAREFULLY AND THOROUGHLY BEFORE ASSEMBLING AND OPERATING
THE HIGH FLY™ TARGET THROWER. MAKE SURE ALL OPERATORS READ AND UNDERSTAND THE
OWNER'S/OPERATOR'S MANUAL.
BASE ASSEMBLY
1. Place the 8mm x 25mm hex bolt upward through the front
hole in rear leg section and place matching left hand hole
in front leg section over bolt. *NOTE: If the target thrower
is to be mounted on a tire, the front leg should be reversed
and horizontal. See diagram at right and on page 5 !
2. Place corner hole of support leg over bolt and install 8mm
lock washer and 8mm hex nut. Place two 8mm x 20mm
bolts upward through remaining two holes and install
8mm lock washers and 8mm nuts. Tighten with wrench.
3. Place eye bolt in small hole of rear leg. Install 4mm nut and
tighten with wrench. Base assembly is complete.
4. If the target thrower is to be mounted on a tire, place 8mm
x 150mm long bolt down through center hole in rear leg
and through lug nut hole in wheel. Install 8mm flat washer
and 8mm hex nut and tighten. If the rear leg section does
not clear the tire, proceed as follows: Remove the 8mm x
20mm bolt from rear of support leg and rear leg assembly.
Replace with 8mm x 150mm long bolt, install 8mm lock
washer and 8mm hex nut and retighten. Put 8mm x 150mm
long bolt down through lug nut hole in wheel, install 8mm
flat washer and 8mm hex nut, then tighten.
5. If the target thrower is to be mounted on a solid foundation
such as a shooting bench, it is advisable to put rubber or
other suitable material between the target thrower and the
foundation in order to give a cushioning effect.
TRIGGER STOP ASSEMBLY
1. Place the stop on the throwing arm so holes are aligned
and the notch faces the near end of the throwing arm.
2. Insert 4mm aluminum post from inside the throwing arm
thru the holes, then screw the 4mm machine screws into
the post and tighten securely with a screwdriver.
2
Publicité
