AUTO-HAK O67 Instructions De Montage page 4

FITTING INSTRCUTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
15
13
14
5
13
M12x40
M12x1,25x40
This towbar is designed to assembly in following cars:
TOYOTA RAV-4, 5 doors model with the spare wheel, produced since
03.2006 till 04.2010 ond since 05.2010 till 01.2013, catalogue no. O67 and
is prepared to tow trailers max total weight 2000 kg and max vertical load
90 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be installed in points described by a car producer.
4
M12x1,25x40
1
M12x75
12
3
From manufacturer
1. For the purpose of installing of the towbar it is not necessary
to disassemble the bumper.
2. From the bottom of chassis members are factory-made
assembly holes. One ought to fix to them side brackets of the
towbar (pos. 4 and 5) using bolts M12x1,25x40mm (pos. 8) –
loosely.
3. Slip the main bar of the towbar (pos. 1) between brackets
(pos. 4 and 5) and fix using bolts M12x40mm.
4. Fix tow-ball (pos. 2) using bolts M12x75mm (pos. 6) from
accessories.
5. Fix the socket plate (pos. 3) as shown on the drawing.
16 6. Tighten all bolts according to the torque shown in the table.
7. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
8. Complete paint layer damaged during installation.
2
After install the towbar you should get adequate note in
registration book (at authorised service station).The car should
be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball
of towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE