Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

FITTING INSTRCUTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
5
M12x40
M12x1,25x40
This towbar is designed to assembly in following cars:
TOYOTA RAV-4, model with the spare wheel, produced since 2009,
catalogue no. O75 and is prepared to tow trailers max total weight 2000 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be installed in points described by a car producer.
4
M12x1,25x40
1
M12x70
M12x75
3
From manufacturer
1. For the purpose of installing of the towbar it is not necessary
to disassemble the bumper.
2. From the bottom of chassis members are factory-made
assembly holes. One ought to fix to them side brackets of the
towbar (pos. 4 and 5) using bolts M12x1,25x40mm (pos. 9) –
loosely.
3. Slip the main bar of the towbar (pos. 1) between brackets
(pos. 4 and 5) and fix using bolts M12x40mm (pos. 8).
4. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts
M12x75mm (pos. 6) and M12x70mm (pos. 7) from
accessories.
13
5. Tighten all bolts according to the torque shown in the table.
6. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
7. Complete paint layer damaged during installation.
2
M6 - 11 Nm
M 12 - 87 Nm
After install the towbar you should get adequate note in
registration book (at authorised service station).The car should
be equipped with:
• Indicators
• Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball
of towbar must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 14 - 138 Nm
NOTE
M 10 - 50 Nm
M16 - 210 Nm

Publicité

loading

Sommaire des Matières pour AUTO-HAK O75

  • Page 1 TOYOTA RAV-4, model with the spare wheel, produced since 2009, NOTE catalogue no. O75 and is prepared to tow trailers max total weight 2000 kg and max vertical load 75 kg. After install the towbar you should get adequate note in registration book (at authorised service station).The car should...
  • Page 2 PPUH AUTO-HAK S.J. Towbar accessories: Produkcja Zaczepów Kulowych Henryk & Zbigniew Nejman 76-200 SŁUPSK ul. Słoneczna 16K tel/fax (059) 8-414-414; 8-414-413 E-mail: office@autohak.com.pl www. autohak.com.pl Towing hitch (without electrical set) Cat. no. Class: A50-X Technical data: D-value: 10,4 kN Designed for:...
  • Page 3 M 12 - 87 Nm M 14 - 138 Nm M16 - 210 Nm numéro de catalogue O75 et est utilisé pour tirer des remorques du poids total 2000 kg et de la pression totale sur la boule max 75 kg. Attention Après le montage du dispositif d'attelage à...
  • Page 4 PPUH AUTO-HAK ż.J. Equipement du dispositif d'attelage à boule: Fabrication des dispositifs d'attelage à boule Henryk & Zbigniew Nejman 76-200 SŁUPSK ul. Słoneczna 16K tel/fax +48 (59) 8-414-414; 8-414-413 E-mail: office@autohak.com.pl www.autohak.com.pl Dispositif d'attelage à boule sans équipement électrique Numéro de catégorie.
  • Page 5 M12 - 87 Nm M14 - 138 Nm M16 - 210 Nm numer katalogowy O75 i słuŜy do ciągnięcia przyczep o masie całkowitej 2000 kg i nacisku na kulę max 75 kg. UWAGA zamontowaniu zaczepu kulowego naleŜy uzyskać wpis w dowodzie OD PRODUCENTA rejestracyjnym pojazdu na „stacji kontroli pojazdów”...
  • Page 6 PPUH AUTO-HAK S.J. WyposaŜenie zaczepu: Produkcja Zaczepów Kulowych Henryk & Zbigniew Nejman 76-200 SŁUPSK ul. Słoneczna 16K tel/fax (059) 8-414-414; 8-414-413 E-mail: office@autohak.com.pl www. autohak.com.pl Zaczep kulowy bez wyposaŜenia elektrycznego Nr kat. Dane techniczne: Klasa: A50-X wartość siły D: 10,4 kN...