THOMSON HT151SB Mode D'emploi page 26

REPAIR AND MAINTENANCE
Consult the following table if there is a problem with the appliance.
Problems
Picture without sound
No sound, no picture
Sound without picture
Poor picture or sound
quality
MAINTENANCE AND CLEANING
• Unplug the appliance before cleaning it.
• Remove fingerprints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance and remove the batteries.
EN 24
Solutions
• Check that the audio connectors are
connected properly.
• Check that the audio connectors are not
damaged.
• Check that the volume is high in the VOL/
CH section.
• Check that the audio parameters have
been correctly defined for the player.
• Check that the audio parameters have
been set up correctly for your television set.
• Check that the sound has not been turned
off.
• Check that ON/OFF is set to ON.
• Check that the plug is plugged in
correctly.
• Check that the electrical cable's plug has
been plugged into the mains socket.
• Check that the indicator light (LED) is lit
up.
• Check the connections.
• Check that the video cable is connected
to the video input of the television set (not
to an audio output).
• Check that your television set's video
input has been selected correctly.
• Check that the video connectors are not
damaged.
• Check that the parameters have been set
up correctly for your television set.
• Check that the audio parameters have
been set up correctly for your television set.
• Check that the disk is clean and not
scratched.
• Check that the AV connectors are in a
good condition.
is a trademark of TECHNICOLOR S.A. used under license to:
Parsons International France S.A.S. - 19 Boulevard Albert Einstein
77420 Champs sur Marne - France
HOME THEATER
HT151SB
Problems
The remote control does
not work
"No disk" is displayed
No sound
Picture dark
Solutions
• Check that the
remote control's
battery is working.
• Point the remote
control towards the
player's infrared
sensor.
• Remove the
obstacles between
the remote control
and the player.
• Make sure that
you have inserted a
disk in the player.
• Check that the
disk has been
inserted correctly.
• Check that
the disk is not
deformed, dirty or
scratched.
• The volume is set
to the minimum
level.
• Make sure that
the disk is not
dirty, scratched or
damaged.
• A pair of
SPEAKERS is
connected to the
unit.
• Adjust the
brightness and
contrast