THOMSON HT151SB Mode D'emploi page 25

USE
RADIO
Manual setting
• Connect the FM antenna to the back of the device.
• Press SCART/FM in the remote control or SOURCE in
the front panel to pass to the TUNER mode.
• Select a radio station and press 5 or 6 to search for
the desired station.
• Press and hold these keys for about two seconds to
start the automated search.
Radio station storage.
The device can store 30 radio stations. You can enter the
radio station or the device can store all the radio stations
automatically in an ascending order.
Default Automatic Programming.
• Press SCART/FM to pass in TUNER mode.
• Press MEMORY for two seconds to start the automatic
research.
• The device scan the radio frequency and automatically
store the radio stations. When all the available radio
stations are stored or the 30 memory sites are full, the
automatic programming stops.
Manual selection
• Select a radio station (see " Manual settings" for more
information).
• Press MEMORY: the number of preset program flashes.
• Using the keypad, select the desired program number,
and then press MEMORY to confirm the selection.
Station recovery
• Press SCART/FM to enter in TUNER mode.
• Press PRESET/7 or PRESET/8 to search the stations
or press the numerical keys directly.
Advice:
• When the FM station broadcasts a found stereo sound,
ST is displayed.
• When you manually adjust a reliable FM station, press
AUDIO in the remote control to pass from stereo to
mono mode. This could help you to reduce background
noise.
• If there is interference, change the position of the
antenna to obtain good reception. TV and other
electronic devices could cause interferences.
• A low level signal can affect the effectiveness of the
«Automatic station programming».
Note:
Adjust the antenna to obtain good reception and an
effective search.
After use, we recommend you turn the device off.
HOME THEATER
HT151SB
Attention: updates to the manufacturer's software must be
certified by an authorised agent.
Updating the software yourself can cause the appliance to
malfunction.
Note: Unit design and specifications are subject to change
without notice. The manufacturer reserves the right to make
the necessary improvements.
TECHNICAL SPECIFICATIONS
• Supported media types: CD, CD-R/RW, DVD, DVD-R/
RW, DVD+R/RW.
• Supported media formats: Audio CD, Video CD, Super
Video CD, HDCD, Kodak Photo CD, DVD.
• Supported codecs: DivX ,XVID, MPEG1, MPEG2,
MPEG4, MP3(VBR), JPEG, Photo CD.
• Software: Possible update
• Pass-band: 20Hz-20 kHz
• Radio audio S/N : >90dB
• THD: 10%
• DAC Audio: 96Khz/24 bit Audio D/A Converter.
• DAC Video: Four pair 12 bit 148 MHz Video D/A
Converter.
• Video resolution: 520 lines or more HDMI out which
576p/720p/1080p output
• Ratio Video S/N: 56dB.
• Audio output (Analogical): Electrical output level: 2V,
resistance: 10 KOhms.
• Video output: Electrical output level 1Vp-p, resistance:
75 ohms not balanced negative.
• Power supply: 230-240V ~ 50/60Hz
• Consumption: 100 W
• Total musical power: 650 max 15W
23 EN