THOMSON HT220 Mode D'emploi page 23

Selection of DVD menu language (8 languages available).
Blocks a DVD to prevent playback by children: Access the
Password Setup menu to enter a password: All audiences,
G, PG, PG13, PG-R, R, NC17, Adult.
Modifying a password. (default password: 1234).
System reset
Resets all settings to their original factory settings.
• Press SOURCE to select the DVD player or the FM
radio player.
• In DVD playback mode, press DVD/USB to switch from
the DVD player or the USB port and back.
Volume setting
Every time the device is started, volume is automatically set
at 10. Max. value is 36.
• Turn the front control dial or press VOL+/VOL- on the
Sound off mode
• Press MUTE on the remote control to turn the sound
on or off.
from the remote control.
• Press FRONT +/-
• Press SW +/-
• Press CEN +/-
• Press SUR +/-
• Insert a DVD/VCD/CD into the disk compartment.
• Close the compartment to enable automatic playback.
• Certain DVDs have their own menus. The player will
automatically display the disk's title menu.
• Press to go back to the title menu.
Note: During playback, press 1x on 3 then TITLE to go
back to the main menu.
• Press 3 to pause playback. On certain disks,
playback can be resumed from the point where it was
interrupted.
• Press 12 or ENTER to resume playback from this point.
• Press 2x to 3 to cancel.
• During playback, press 7 to return to the beginning of
the chapter. Each time this key is pressed, one chapter
is skipped backwards up to the DVD root menu.
• Each time 8 is pressed, one chapter is skipped
forwards.
• Press 6 during playback to move quickly forwards.
Each time this key is pressed, scrolling speed is
• Press 5 during playback to move quickly backwards.
Each time this key is pressed, scrolling speed is
• Press 12 or ENTER to resume normal playback speed.
HOME CINEMA
HT220
TO AN USB FLASH DRIVE
The device enables conversion of audio tracks to MP3
format to save them on a connected USB drive.
Procedure:
bar will appear on the screen.
When conversion is completed, press EXIT on the menu.
To play converted tracks, press DVD/USB.
Note
• Press 12 to interrupt playback.
• Press 12 or
• Press SLOW to start thorough playback. Each time this
• Press 12 or
• Insert an audio CD into the DVD player.
• Upon playback start, press
menu will appear on the screen.
• Select the tracks for conversion on the right and press
ENTER
• Press START on the screen to launch conversion.
• Press CANCEL on the menu to stop CD conversion.
USE
: The CD Ripping
The ripping progress
21 EN